Making a ribbon stay curled and watching a curved ribbon spring back are different problems. One concerns a lasting change in shape; the other concerns motion after release.

A lasting difference through the thickness
In 2016 experiments by Chris Prior and colleagues, strips cut from PVC transparency film passed over blades under controlled tension. Their model explained the remaining curl through unequal permanent stretching across the strip’s thickness, rather than a ribbon simply holding its temporary bend.
More tension did not always mean a tighter curl. For the sharper blades, curvature increased to a maximum and then decreased as the load rose. At fixed loads in the speed tests, faster pulling produced looser curls. Time available for stress relaxation therefore mattered alongside geometry.
These results concern a tested polymer and controlled apparatus, not every fabric ribbon. They explain a material response; they are not instructions for handling sharp blades.
Releasing an already curved strip
A 2012 study by Callan-Jones, Brun and Audoly addressed a different starting point: a naturally curved elastic strip held flat on a hard, nonadhesive surface. Releasing one end allowed a curling region to travel along it.
Combining experiments, simulations and theory, the researchers found a constant-speed front and a curl with a repeating shape after rescaling. At long times, its size grew with the cube root of elapsed time. A small roll near the free end had approximately constant curvature.
This describes release of an existing curve, not the permanent shaping process.

Width and surroundings affect the motion
In 2014 experiments by Albarrán Arriagada, Massiera and Abkarian, naturally curved ribbons were flattened and released in air or water. The early movement of the curling front depended on ribbon width. Later, material wrapped into a roll at constant speed, with a radius different from its natural radius.
Their energy balance included elastic and kinetic energy, gravity, and energy lost internally and to the surroundings. A moving curl therefore need not have the same radius as an undisturbed ribbon.
Our wet-paper article describes another route to bending. Similar-looking curves can reflect different material histories; appearance alone does not identify the mechanism.

Leave a Reply