Why Does a Thin Stream of Honey Coil Up?

By

·

A falling thread of honey can bend into a little stack of loops instead of spreading immediately. This liquid-rope coiling is a flowing instability, not evidence that the honey has become a solid spring.

A thin stream of honey falling from a measuring cup into a clear bowl.
Everyday honey pouring, not a measured coiling experiment. Photo: Bridget Brown / Alabama Extension, CC0; resized.

Fall height does not set one simple speed

In 2004 experiments, M. Maleki and colleagues studied liquid ropes landing on a solid surface. They distinguished regimes dominated by viscous, gravitational or inertial effects. Which behavior appeared depended on viscosity, density, flow rate and fall height, rather than height alone.

As height increased, the coiling frequency first decreased and then increased. In a transitional range, the researchers also observed switching between two coiling states. Their measured frequencies agreed closely with numerical predictions.

That result makes a useful distinction: increasing the distance of a fall does not necessarily produce a uniformly faster turning coil. The balance of forces can change, and more than one state can occur under some conditions.

Steady pouring can make a steady stack

Frank Austin Mier and colleagues used controlled pumping and high-speed imaging in a 2018 honey study. As the falling liquid slowed on arrival, it accumulated into a rotating stack while liquid also flowed outward into the surrounding reservoir.

Their apparatus let them vary flow and height separately. Under their tested conditions, transitions between gravitational and inertial coiling were smooth; they did not observe a persistent intermediate unsteady regime. A disturbance could briefly disrupt the coil, but steady coiling returned.

Annotated research photograph of a honey thread curling into a stack, with a two-millimeter scale bar.
Honey-coil dimensions and tracking locations. Figure 1: © 2018 Mier and colleagues, CC BY 4.0; unmodified.

This does not erase earlier observations of switching. It shows why a transition should be described together with the particular fluid, flow and geometry used to produce it.

Move the surface and circles become stitches

A 2015 study by P.-T. Brun and colleagues considered a falling viscous thread landing on a moving belt. Depending on the motion, the deposited thread made meanders, alternating loops and other stitch-like patterns rather than simply stacking circles.

These patterns accommodated the mismatch between the belt speed and the arriving thread’s speed. Numerical simulations showed that inertia was not required to generate the studied patterns. A simplified geometrical model reproduced their forms and their sequence as belt speed changed.

The moving-belt result concerns a different setup from a stationary plate, not a rule that inertia never matters in coiling. Compare water glugging from a bottle: there, air exchange shapes the outflow. Similar-looking interruptions in pouring can arise from different mechanisms.

Add comment

Leave a Reply